BNQSQ - 5605, TEMPO ZINC CHROMATE PRIMER
- MSDS: BNQSQ
- Manufacturer: PLASTI KOTE CO INC
- Product Name: 5605, TEMPO ZINC CHROMATE PRIMER
- National Stock Number: 8010-00N030857
Product Identification
Product ID:5605, TEMPO ZINC CHROMATE PRIMER
MSDS Date:01/20/1987
FSC:8010
NIIN:00N030857
MSDS Number: BNQSQ
Responsible Party
MEDINA, OH 44256
US
Emergency Phone: 216-725-4511
Info Phone: 216-725-4511
Cage: 07778
Contractor
Telephone: 330-725-4511
Cage: 07708
Ingredients
5.1 @ 20C
CAS: 1330-20-7
RTECS: ZE2100000
Fraction By Weight: 25-30%
OSHA PEL 100 PPM;150 PPM STEL
ACGIH TLV: 100 PPM;150 PPM STEL
EPA Report Quantity: 1000 LBS
DOT Report Quantity: 1000 LBS
SOLVENT NAPHTHA, (PETROLEUM) LIGHT ALIPHATIC; (LACOLENE
CAS: 64742-89-8
Fraction By Weight: 15-20%
OSHA PEL 200 PPM (MFR)
ACGIH TLV: 500 PPM (MFR)
186 @ 20C
CAS: 67-64-1
RTECS: AL3150000
Fraction By Weight: 10-15%
OSHA PEL 1000PPM
ACGIH TLV: 750PPM/1000STEL;9293
EPA Report Quantity: 5000 LBS
DOT Report Quantity: 5000 LBS
CHROMATE (1-), HYDROXYOCTAOXODIZINCATEDI-, POTASSIUM; (ZINC
CAS: 11103-86-9
RTECS: GA9170000
Fraction By Weight: 5-10%
OSHA PEL 0.1(CRO*3) PPM, C
ACGIH TLV: 0.05 (CR) MG/M3
PROPELLANT MIXTURE CONSISTING OF INGREDIENTS 6, 7 & 8
RTECS: 9999999ZZ
Fraction By Weight: 23%
PROPANE
CAS: 74-98-6
RTECS: TX2275000
OSHA PEL 1000 PPM
ACGIH TLV: SIMPLE ASPHYXIANT
PROPANE, 2-METHYL-; (ISOBUTANE)
CAS: 75-28-5
RTECS: TZ4300000
BUTANE
CAS: 106-97-8
RTECS: EJ4200000
OSHA PEL 800 PPM
ACGIH TLV: 800 PPM
NON HAZARDOUS INGREDIENTS
Fraction By Weight: 15-20%
VENTILATION TO MAINTAIN EXPOSURE BELOW TLV'S.
RTECS: 9999999ZZ
SEVERE OVEREXP IN LAB ANIMALS HAS ALSO
RTECS: 9999999ZZ
SPLEEN. INTENTIONAL MISUSE BY DELIB CONC & INHALING
RTECS: 9999999ZZ
W/METHYLENE CHLORIDE MAY CAUSE IRRIT, DEFATTING &
RTECS: 9999999ZZ
>1500F,>816C.
RTECS: 9999999ZZ
Hazards
LD50 LC50 Mixture:NONE SPECIFIED BY MANUFACTURER.
Routes of Entry: Inhalation:YES Skin:NO Ingestion:YES
Reports of Carcinogenicity:NTP:YES IARC:YES OSHA:NO
Health Hazards Acute and Chronic:ACUTE: INHAL:EXCESS INHAL OF VAPS CAN
CAUSE NASAL & RESP IRRIT, DIZZ, WEAKNESS, FATG, NAUS, HDCH, POSS
UNCON & EVEN ASPHY. METHYLENE CHLORIDE HAS CAUSED LOSS OF
CONSCIOUSNESS & DEATH AS LOW AS 10,000 PPM & CAUSES NUMBNESS IN
ARMS & LEGS PLUS RAPID HEARTBEAT ABOVE 7000 PPM. EYE:CAN CAUSE
SEVERE IRRIT, (EFTS OF OVEREXP)
Explanation of Carcinogenicity:ZINC POTASSIUM CHROMATE: KNOWN
CARCINOGEN (NTP), GROUP 1 (IARC).
Effects of Overexposure:HLTH HAZ: REDNESS, TEARING, BLURRED VISION.
CONT LENSES SHOULD NOT BE WORN. INGEST:CAN CAUSE GI IRRIT, NAUS,
VOMIT, DIARRHEA. SKIN:METHYLENE CHLORIDE IS PAINFUL & IRRIT IF
CONFINED TO SKIN BY GLOVES, CLOTHING, ETC. CHRONIC:RPTS HAVE ASSOC
RPTD & PRLNGD OCCUP OVEREXP TO SOLV W/PERM BRAIN & NERVOUS SYSTEM
DMG. (ING 11)
Medical Cond Aggravated by Exposure:CAN CAUSE ALLERGIC RESPIRATORY
AND/OR SKIN REACTION.
First Aid
First Aid:INHAL:REMOVE INDIV TO FRESH AIR.IF BRTHG DFCLT, ADMIN
OXYGEN.IF BRTHG STOPS, GIVE ARTF RESP & CALL MD.EYES:FLUSH W/ WATER
FOR AT LEAST 15 MIN WHILE OCCASNLY HOLDING LIDS OPEN.CALL
MD.INGEST: DO NOT IN DUCE VOMIT (ASPIR OF MATL INTO LUNGS CAN CAUSE
CHEM PNEUM, WHICH CAN BE FATAL).KEEP PERSON WARM, QUIET & CALL
MD/POISON CTL CTR. SKIN:WASH W/SOAP & WATER/VARIOUS HAND CLEANERS.
WASH CLTHG BEFORE REUSE
Fire Fighting
Flash Point:PROPELLANT=-100F
Lower Limits:1.0%
Extinguishing Media:"ALCOHOL" FOAM, CO2, DRY CHEMICAL.
Fire Fighting Procedures:WEAR NIOSH/MSHA APPRVD SCBA & FULL PROT EQUIP
.WATER SPRAY MAY BE INEFT.WATER MAY BE USED TO COOL CLSD CNTNRS TO
PVNT PRESS BUILDUP & POSS (SUPP DATA)
Unusual Fire/Explosion Hazard:CLSD CNTNRS MAY EXPLODE AND/OR AUTOIGNITE
WHEN EXPSD TO EXTREME HEAT.VAPS ARE HVR/AIR & MAY TRAVEL ALONG
GROUND/MAY BE MOVED BY VENT & IGNITED BY (SUPP DATA)
Accidental Release
Spill Release Procedures:ELIMINATE ALL IGNITION SOURCES. EVACUATE AREA.
VENTILATE & AVOID BREATHING VAPORS. TURN OFF HEATING AND/OR AIR
CONDITIONING TO PREVENT VAPS FROM CONTAM BLDGS. ABSORB LIQ ON
PAPER, VERMICULITE, FLOOR A BSORB/OTHER ABSORB MATL & TRANSFER TO
CLSD CNTNRS.
Neutralizing Agent:NONE SPECIFIED BY MANUFACTURER.
Handling
Handling and Storage Precautions:DO NOT STORE IN AREAS ABOVE 120F OR IN
DIRECT SUNLIGHT, OR NEAR HEAT OR OPEN FLAMES. DO NOT PUNCTURE OR
INCINERATE.
Other Precautions:STORE LARGE QUANTITIES IN BUILDINGS PROTECTED FOR
STORAGE OF NFPA/OSHA CLASS 1A FLAMMABLE LIQUIDS.
Exposure Controls
Respiratory Protection:FOR CASUAL OR OCCASNL USE-TO AVOID BRTHG VAPS/
SPRAY MIST, OPEN WINDOWS & DOORS/USE OTHER MEANS TO ENSURE FRESH
AIR ENTRY DURING APPLICATN & DRYING.WHERE VAP CONC IS >100 PPM, A
NIOSH/MSHA APPROVED OR GANIC VAPOR TYPE RESPIRATOR IS ADVISED.
Ventilation:DO NOT USE IN CONFINED/CLSD SPACE.FOR REGULAR/CONTINUOUS
USE, PROVIDE SUFF MECH (GENERAL) AND/OR LOCAL EXHST (ING 10)
Protective Gloves:CHEMICAL RESISTANT SUCH AS NEOPRENE.
Eye Protection:CHEM WORK GOG & FULL LENGTH FSHLD
Other Protective Equipment:SOLVENT RESISTANT BOOTS, APRON, HEADGEAR
AND/ OR FACESHIELD SHOULD BE WORN WHERE SPLASHING IS POSSIBLE.
Work Hygienic Practices:WASH HANDS BEFORE EATING OR USING WASHROOM. AS
WITH ALL CHEMICALS, MINIMIZE PERSONAL CONTACT AND/OR BRTHG OF
VAPORS.
Supplemental Safety and Health
EVAP RATE:PROPELLANTS <1 (BUAC=1); SLOWER THAN ETHER (PROPELLANT
FASTER). FIRE FIGHT PROC:AUTOIGNIT/EXPLO WHEN EXPSD TO EXTREME
HEAT. IF WATER USED, FOG NOZZ PREF. EXPLO HAZ:PILOT LIGHTS, OTHER
FLAMES , SPARKS, HEATERS, SMOKING, ELEC MOTORS/OTHER IGNIT SOURCES
AT LOCATIONS DISTANT FROM MATL HNDLG POINT.
Chemical Properties
HCC:V3
Boiling Pt:B.P. Text:>133F,>56C
Melt/Freeze Pt:M.P/F.P Text:SEE ING 14
Vapor Pres:SEE INGRED
Vapor Density:HVR/AIR
Spec Gravity:<1 (H2O=1)
Evaporation Rate & Reference:PRODS >1 (SUPP DATA)
Solubility in Water:SLIGHT TO MODERATE
Appearance and Odor:TYPICAL SOLVENT PAINT.
Percent Volatiles by Volume:80-85
Stability
Stability Indicator/Materials to Avoid:YES
STRONG OXIDIZING AGENTS, HEAT, ALKALIES, HOT SURFACES AND REACTIVE
METALS.
Stability Condition to Avoid:HEAT, SPARKS, AND OPEN FLAME.
Hazardous Decomposition Products:MAY FORM TOX MATLS, NITROGEN CMPDS,
ETC, CO2 & CO, HCL, PHOSGENE (SM AMTS) & VARIOUS HYDROCARBONS WHEN
BURNED.
Disposal
Waste Disposal Methods:MATERIAL COLLECTED ON ABSORBENT MATERIAL MAY BE
DEPOSITED IN A POSTED TOXIC SUBSTANCE LANDFILL IN ACCORDANCE WITH
FEDERAL, STATE AND LOCAL REGULATIONS.
Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.